Eureka Tents Tent Backcountry 1 User Manual

Assembly Instructions  
for Backcountry 1  
• At the opposite corner, grasp the web and  
simultaneously push the pole to form an arc. Insert the  
post end into the grommet on the corner stake-out  
web. Repeat with the second pole. See fig.3.  
Component List:  
1 Tent Body 1 Tent Fly 1 Tent Bag 2 Tent Poles  
1 Pole Bag 1 Fly Rod 1 Set Stakes w/Bag  
NOTE:  
Do not drop tent bag or pole bag on its end. Do not bounce  
tent bag on its end to get the tent out. These actions may  
cut the shock cord and/or damage the pole ends.  
fig.7  
fig.6  
Assembly:  
fig.3  
• Unpack the tent bag. Unfold the tent and lay it out, with  
the floor on the ground with a grommeted web in each  
corner. Pull the tent into a rough rectangle. Do not stake  
down the tent just yet; but in windy conditions, stake  
down one corner that faces into the wind.  
• Raise the poles over the tent  
and place it in the desired  
location.  
• Assemble the shockcorded tent poles and fly rod.  
Carefully seat each section. Try to keep the poles from  
snapping together as this can damage the ends.  
Turn the fly right side up and drape it on  
the tent with the Eureka! logo over the  
door. Reach under the fly and wrap each  
Velcro® strap around a pole. See fig.8.  
fig.8  
Working your way around the  
tent, attach all the clips from  
the corners of fly to the poles.  
fig.4  
• At the front of the tent body at A, slide a pole diagonally  
across the tent, through the sleeves, to the opposite side  
B. Follow the seam from sleeve to sleeve. Push the pole,  
don’t pull it. Continue with the second pole through its  
sleeves from C to D. See fig.1.  
See fig.4.  
• Attach the web buckle from each corner  
of the fly to its mate on the corner tent  
web. Adjust the web to proper tension.  
See fig.9 & fig10.  
• With the corner clips attached, square the tent. Use a  
metal skewer to stake out each corner web.  
See fig.5.  
A
C
fig.9  
B
D
fig.1  
fig.10  
fig.5  
Your Tent is Ready!  
• Insert the post end of a  
pole into a grommet on  
the corner stake-out  
web. See fig.2.  
Take down:  
• Unroll the fly, upside down, on the ground. Locate  
the web pockets in the center of the fly and insert  
the assembled fly rod into these pockets.  
See fig.6 & fig.7.  
Pull up stakes and open doors. Pull posts out of the grommets and  
push poles out of the sleeves. Collapse the tent poles and stow.  
Fold the tent and fly thirds. Roll up both towards the door and stow.  
fig.2  
Rev. D 4-09  
 

Aastra Telecom Telephone 9116 User Manual
Acer Computer Monitor UMHS5AA001 User Manual
Acer Computer Monitor X173 User Manual
ADIC Switch Switches User Manual
Advantech Laptop MIC 3318 User Manual
Alvin Patio Furniture CH25A User Manual
American Standard Indoor Furnishings T373700 User Manual
Audiovox Stereo Amplifier AMP 602 User Manual
Avocent Switch DSR1021 User Manual
Axis Communications Security Camera 210 User Manual